Fuel Pump Test and ReplacementTest1. Remove rear seat.2. Remove access panel (4 screws).3. Disconnect the 2P connector. CAUTION: Be sure to turn ignition switch OFF, before disconnecting the wires.4. Disconnect the main relay connector and connect the BLK/YEL (5) wire and YEL/GRN (7) wire with a jumper wire.5. Check for battery voltage at the fuel pump connector, when ignition switch is turned ON (position II). Attach red test probe to the YEL/GRN wire and negative probe to the BLK wire. If battery voltage is available, replace the fuel pump. If there is no voltage, check fuel pump ground and wire harness.Replacement1. Relieve fuel pressure, by removing fuel tank cap.2. Remove rear seat.3. Remove access panel (4 screws).4. Disconnect fuel lines and connector.5. Remove fuel pump mounting nuts.6. Remove fuel pump from fuel tank.WARNING: Do not smoke while working on fuel system. Keep open flames away from work area. News source: Ask Me Help Desk